Operations; Operating - PROTEC.class PSZM 05102992 Mode D'emploi

Operations

Operations
Thank you for choosing the PROTEC.class
The PROTEC.class
measuring voltages that do not exceed 300 V (AC or DC) in relation
to the earthing.

Operating

This meter should be allowed to acclimate with the surroundings be-
fore measuring.
|
The user of this clamp meter must comply with all relevant safety
regulations.
| The meter may display false readings when used in the vicinity of
devices which are generating noise or interference.
| This meter should only be used as described in these instructions.
Any other use could affect this device's safety system.
|
To avoid damaging the meter, never exceed the maximum input val-
ues listed in the technical specifications.
| Always make sure that the mode selection switch is in the proper
position before starting each measurement.
| You must use extra caution when working around uninsulated wires
or busbars.
| Any accidental contact with a conductor can cause an electrical
shock.
|
Be careful when working with voltages over 60 VDC or over 30
VAC RMS. Such voltages pose a risk of electric shock.
| The clamping jaws must always be taken off the test circuit before
switching to another function.
| Keep your fingers behind the PROTECtive ring while measuring.
|
To avoid false readings: Change the batteries whenever the
appears.
®
PSZM should be used in CAT-III systems for
26
®
PSZM.
icon