Publicité
Les langues disponibles
Les langues disponibles
5.
Form each spacer into a half octagon shape, folding gently at the perforations as shown in FIGURES B & C. Bend each
section 45 to 50 using the bend template below (DO NOT OVERBEND).
FOLD LINES
45 MIN
50 MAX
BEND TEMPLATE
FIGURE
B
FIGURE
C
6.
Align tabs and slots on the formed spacer halves [6] and lower into floor box opening. Blind nuts [7] should be
stacked on top of each other, SEE FIGURE D. NOTE: If more than one set of spacers are installed, stagger location of
joints, SEE FIGURE E.
7.
Install four #8-32 pan head screws supplied with the spacer kit to secure the spacer halves. Tighten to 10 - 15 lbs-in
torque [1.1 - 1.7 N m]. NOTICE: Each set of spacers adds 3/4" [19 mm] to the minimum pour depth of the box.
7
FIGURE
STAGGER JOINTS
FIGURE
6
D
E
Publicité
