Cequent Performance Products 75940 Instructions D'installation page 3

NOTE: for models without Fascia popout.
1. Locate the scribed sections on the inside of the bumper fascia.
2. Locate the section indicated with USA.
Scribe a line approximately 1" from the left side of the USA scribed section. From the top of the section to the bottom.
3.
NOTE: This section should be no greater than 6 ¼" from top to bottom, measured from the bottom of the "A" in USA.
Scribe a line approximately 3 ¾" from the scribed line in Step 3. (Approximately 4 ¾" from left side of USA section)
4.
Scribe a line from the top of the section to the bottom.
5. Cut out scribed section.
"USA" Section
Scribe line 1" from left side of USA Section.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Cequent Performance Products – Printed in Mexico
© 2014
Fascia Trimming Instructions
Audi Q5
Top to bottom of section should be no greater
Than 6 ¼"..
Cut out scribed Section.
Scribe line 3 ¾" from previously scribed line,
(4 ¾" from left side of USA section)
Sheet 3 of 9 N75940 08-25-14 Rev. A
Form: F205 Rev A 5-6-05