Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Safety
ATTENTION: Read carefully before attempting to
install, operate or service your pump. Protect your-
self and others by observing all safety information
and additional instructions included with this equip-
ment. Failure to comply with instructions could
result in personal injury and/or property damage!
Retain for future reference.
DESCRIPTION
This submersible pool cover pump is intended for
water removal from swimming pool covers. Unit is
constructed of high-impact corrosion-resistant plastic.
Screened inlet prevents large solids from entering
pump.
SPECIFICATIONS
Power supply required........................115V, 60 HZ.
Motor ..............................................................16 W
Motor duty.............................................Continuous
Thermal Protector ....................................Automatic
Liquid Temp. Range......................Max. 25°C (77°F)
Operation Position ..................................Horizontal
Circuit Requirement (min.) ..........................10 Amp
Dimensions (Overall) ...................6 3/8 x 4 7/8 x 3"
Power Cord Set .................................Vinyl, 3-prong
Discharge ........Horizontal male garden hose thread
PUMP CAPACITY
Head in feet
0
1
3
Head in metres
0
0.3
0.9
Litres/minute
16.8
14.9
12.9
Gallons/minute 6 1/2 5 3/4
5
NOTICE: This unit is not designed for applications
involving salt water or brine!
GENERAL SAFETY
INFORMATION
1.
Know the pump application, limitations, and
potential hazards.
Do not use in explosive
atmospheres. Pump water only with this pump.
Failure to follow this warning can result in per-
sonal injury and/or property damage.
2.
Make certain that the power source conforms to
the requirements of your equipment.
3.
Disconnect power before servicing.
4.
Secure the discharge line before starting the
pump. An unsecured discharge line will whip,
possibly causing personal injury and/or proper-
ty damage.
For parts or assistance, call Customer Service at
5.
Check hoses for weak or worn conditions
before each use, making certain that all con-
nections are secure.
6.
Periodically inspect pump and system compo-
nents. Perform routine maintenance as required
(See MAINTENANCE Section).
7.
Provide a means of pressure relief on pumps
whose discharge line can be shut-off or obstruct-
ed.
8.
Personal Safety:
a. Wear safety glasses at all times when work-
ing with pumps.
b. Keep work area clean, uncluttered and
properly lighted – replace all unused tools
and equipment.
c. Keep visitors at a safe distance from the
work area.
d. Make workshop child-proof – with pad-
locks, master switches, and by removing
starter keys.
9.
This equipment is only for use on 115 V (single
phase) and is equipped with an approved 3-
conductor cord and 3-prong, grounding-type
plug.
shock, be certain that it is connected to a
properly grounded, Ground Fault Circuit
Interrupter (GFCI) protected, grounding-type
receptacle. Do not lift pump by the power
5
7
cord; always lift it by the handle.
1.5
2.1
Where a 2-prong wall receptacle is encoun-
tered, it must be replaced with a properly
7.1
0
grounded, GFCI protected, 3-prong receptacle
2 3/4
0
installed in accordance with all applicable
codes and ordinances.
10. Protect electrical cord form sharp objects, hot
surfaces, oil, and chemicals. Avoid kinking the
cord. Replace or repair damaged or worn cords
immediately.
11. Do not touch operating motor. Modern motors
can operate at high temperatures.
12. Power Supply: Pump is designed for 115 V,
60 Hz operation and requires a circuit of
10 amperes or more capacity. It is supplied
with a 3-wire cord set with grounding-type
plug for use in a 3-wire, grounded outlet. To
reduce risk of electrical shock, plug pump into
a Ground Fault Circuit Interrupter (GFCI).
Consult a local electrician for availability and
installation. For safety, circuit should always be
electrically grounded to a suitable electrical
ground such as a grounded water pipe or a
properly grounded metallic raceway, or ground
wire system. Do not cut off the round ground-
ing prong.
1-877-455-5508
2
To reduce the risk of electric
Publicité
Table des Matières
