Sauder 412320 Mode D'emploi page 12

Step 8
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the upper diagram below.
å
Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the LEFT END (B) and LEFT UPRIGHT (C). Use four GOLD 5/16" FLAT HEAD
å
SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
å
of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
Finished edge
Open end
Page 12
35MC
Finished edge
3
2
B
1
L
35MA
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
3
Q
M
412320
3S
Open end
1
M
2
C
www.sauder.com/services