Publicité
Les langues disponibles
Les langues disponibles
MOUNTING THE RANGEHOOD
1. Screw mounting brackets onto left and right side of blower unit.
2. Attach blower to canopy, fasten with screws from below.
3. Determine hood height, center, mark, level and hang hood to wall through mounting keyholes
on back.
4. Install duct work and electrical.
5. Locate and fasten bracket for upper telescopic duct cover onto the wall.
6. Slip upper and lower telescopic duct covers onto top of blower and screw in place.
7. Secure hood to wall studs whenever possible; use appropriate wall fasteners & hardware
(not supplied) for hollow drywall, tiled, concrete, brick wall applications for mounting hood.
Note: Butterfly damper may be installed by placing it ontop of the motor housing.
INSTALLATION
mounting
brackets
6
Publicité
