Fitting Instructions; Safety Instructions; Use And Maintenance - UMBRA RIMORCHI 01053 Instructions De Montage

Masquer les pouces Voir aussi pour 01053:

Instructions de montage (30 pages)

Table des Matières

Les langues disponibles

Remove below the vehicle any mastic from contact points between the chassis and the tow bar; then paint

mastic free pieces with rust inhibitor.

Lift the boot's internal coating, remove the spare wheel from its housing, remove the heat-guard's

bearing of the silencer and follow with the cutting as indicated on the drawing;

Eliminate the rear right screw of the heat-guard fixing bearing under the car only if it interferes;

Place the counter-plate "D" inside the boot, touching the body's rear and lateral side and drill the

floor referring to the holes "2" and "4". Remove the counter-plate. Widen the holes "2". Insert the

spacers "E", replace the counter-plate and fix interposing the washers under the car on points "4";

Place the counter-plate "B" inside the boot touching the body's rear side and the spare wheel

housing's side and drill the floor referring to the holes "2" and "3". Remove the counter-plate, widen

the holes "2", insert the spacers "E", replace the counter-plate, insert the screws and fix interposing

the plate "C" under the stringer, fixing it only on the furthest point;

Back together the heat-guard bearing, fixing it to the original screws on the front side while place it

on the screw "2" on the rear side;

Place the cross bar "A" referring to the holes "2" on the right and to the holes "3" on the left

interposing the washers in position "3" and fix;

Tighten all bolts and nuts as shown in the enclosed layout;

Connect the wiring to the socket, following the car booklet's instructions "use and maintenance" as

shown in the enclosed wiring kit layout;

Only for 1 SERIES: Make a hole on the bumper as shown in the enclosed layout;

10.

Back together the boot's internal coating and put back the spare wheel in its housing.

•

Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify that the

vehicle's towing disposal quoted on the car registration at the points D.1/ D.2 is mentioned on the

tow bar document. Otherwise ask the proper office for explanation or updated documents.

•

For safety, all work involving tow bar installation must be undertaken by skilled technicians.

•

Damaged components must be replaced with manufacturer's spares parts by qualified staff.

•

It is forbidden to make any modification or structural repair to the tow bar.

•

The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be

checked at regular intervals. If the tow ball measures less than 49 mm after selected readings

across the diameter, the tow ball must be replaced with a new one.

•

After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.

The tow bar installer must fix at the same level with the ball in a clear position, a plate with the ball's maximum

load for the vehicle on which the tow bar is fitted.

www.umbrarimorchi.it - umbrarimorchi@umbrarimorchi.it