Publicité
Les langues disponibles
Les langues disponibles
Note 2.
Compass Rallye Package
It is necessary to trim bumper
fascia. Obtain vehicle owners
approval for cutting plastic
fascia before installing hitch!
See diagram
Figure 3
Fascia Trimming Diagram for
2011 & Later Jeep Patriot and
Compass Models
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
©
2010, 2011, 2011, 2014, 2015 Cequent Performance Products –
.
Rear view of Rallye showing
section of fascia to trim out
Figure 2
Jeep Compass Rallye Model
Printed in México
COMPASS
Shown with hitch in place.
COMPASS
3"
Cut up to cross hatch pattern in fascia
*2011 and Later Jeep Patriot and Compass models
require fascia trimming for hitch installation. Obtain
vehicle owner approval before cutting.
Frame
Figure 4
** X (from ground to bottom of frame) must be
measured to double check placement of cut. X-5
inches is the distance measured from the ground
to the top of the fascia cut.
Sheet 2 of 6
75712N
Part Number:
75712
87606
44661
Ground
2-14-17
Rev. K
Form: F205 Rev A 5-6-05
Publicité
