Helpful Tips; Cleaning & Maintenance - NOSTALGIA PRODUCTS FHCM4BR Instructions Et Recettes

HOT & COLD FROTHING
Use these settings to create hot or cold milk froth for lattes,
mochas, cappuccinos, and other similar beverages.
1. Place the HOT CHOCOLATE & MILK FROTHER upright on a dry,
sturdy and heat-resistant surface near an electrical outlet.
2. Take the lid off and insert the frothing paddle onto the shaft on the bottom of the frother.
3. Fill the jar with the desired amount of milk and put the lid on.
NOTE: Minimum milk capacity is 3 oz. Max capacity is 7 oz. Type of milk used
may vary. Do not fill past the dashed "Cold/Hot Milk Froth" fill lines.
4. Connect the plug into an electrical outlet and place frother onto base.
5. Press the COLD FROTH or HOT FROTH Button once and the indicator
light will illuminate. This will begin frothing process.
NOTE: This setting will take approximately 50 to 90 seconds. The frother
will turn off automatically when cycle is finished. If you want to stop the
frothing process at any moment, press ON/OFF button once.
6. Remove lid, pour out froth, and enjoy.
CAUTION: Minimum 3 minutes rest time must be maintained between cycles
otherwise frother will stop and will flash, indicating that it needs to cool down.

HELPFUL TIPS

NEVER leave the unit unattended while operating.
SMOKING
A small amount of smoke and/or odor may occur upon heating
due to the release of manufacturing oils. This is normal.
NOISE
Some minor expansion/contraction sounds may occur
during heating and cooling. This is normal.
HEATING BEVERAGES
DO NOT run the HOT CHOCOLATE & MILK FROTHER on the "WARM MILK"
setting for more than 15 minutes. This will cause milk to scald.
CLEANING & MAINTENANCE
1. After using your HOT CHOCOLATE & MILK FROTHER, disconnect from electrical outlet.
Remove plug by gripping the plug body and pulling out of the outlet. Never yank or
twist cord to unplug the unit. Allow the appliance to cool completely before cleaning.
2. Pour out any unused beverage.
3. Wash the interior of the Mixing Container with a combination of mild detergent and
water. DO NOT submerge the Mixing Container in water. Rinse and dry thoroughly.
4. Wash the lid in warm, soapy water. Rinse and dry thoroughly.
5. Wipe the exterior of the Base and Mixing container with a soft, damp cloth.
6. NEVER immerse Base in water or put any parts in the dishwasher.
7