Kolpin 2708 Instructions D'installation page 2

b) Install the windshield to the vehicle using supplied hardware (Item C). Adjust the position of the windshield and tighten.
Caution: over tightening any hardware could cause irreversible damage to the windshield.
Explode view
Phillips
Shoulder
truss head
washers
Rubber
screws
¼"
washers
¼"-20 x 1"
2. Maintenance and Car
Tighten all hardware after first use and periodically thereafter.
Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO
To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol,
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual
Fantastik
2708 - Instructions CANAM MAVERICK Full Fixed Windshield MR - rev00
Clamp 2"
(loop type)
Nylon
¼"
locknuts
¼"
Clamp 2"
(loop type)
NOT SCRUB or use brushes or squeegees.
Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
then wash and rinse. DO NOT USE GASOLINE.
hazing, loss of light transmission and coating delamination.
Aqueous Solution of Soaps and Detergents
Joy Formula 409
Rubber
washer ¼"
Shoulder
washer ¼"
Phillips truss head screw
¼"-20 x 1"
CLEANING:
Compatible Cleaning Agents
Mr. Clean Top Job
Detailed view of clamp
Nylon
locknut ¼"
FRONT
VM&P grade Naphtha Hexcel, F.O. 554
WWW.KOLPIN.COM
Clamp 2"
(loop type)
Windshield
Neleco-Placer
2