Kolpin POLARIS RANGER 400 Instructions D'installation

READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLATION TO
AVOID INJURY TO YOURSELF, DAMAGE TO THE VEHICLE OR ACCESSORY.
 Torque specifications must be followed when tightening bolts. Over-tightening any and/or all screws will cause
 As specified on carton label, once protective film on shields is removed, product cannot be returned.
 As specified on carton label, damage caused by packaging staples is not covered by warranty. All staples must be
 Failure to follow these installation instructions completely may void any warrantable components and result in
 Do not use Loctite or any other similar fastener adhesive. These types of products react to plastics and cause
 Our windshields are made from the highest quality material providing optimum transparency and clarity.
Blurriness and/or extrusion marks may or may not appear when looking through windshield from a wide, side-
 The application of improper cleaners, abrasive and/or dirty cleaning towels can severely damage the product.
Failure to follow cleaning recommendation (provided herewith) may void any warrantable components.
These instructions contain important information for future reference and must be given to the customer at time of
ITEM PART NAME
A
B Clamp sets (1 ¾" dia.)
INSTRUCTION C Clamp sets (1 ¾" dia.)
BAG
D
1. Installation
a) Attach clamps (Item B & C) to the roll cage of your vehicle using supplied
hardware (Item D) as shown. Note that only the 4 clamps that are located on
middle section of the roll cage need the clamp spacers. Do not tighten the
clamps to the roll cage at this stage; you will need to make adjustments
later on.
2732 - Instructions POLARIS RANGER 400 Rear Windshield GP - rev01
IMPORTANT NOTICES
 For proper installation, TWO people are required .
cracks around mounting holes which is not covered by any warranty.
removed prior to removing product from carton.
product damage or personal injury.
cracking. Not covered by any warranty.
angle. This is normal for all extruded clear plastic materials.
purchase or upon completion of installation.
Parts List
(parts available with kit only and not available separately)
Windshield
Includes : 8 socket cap screws M6 x 20, 6 coupling nut M6, 2 nylon locknuts M6, 10 plastic shoulder
Hardware
washers M6, 6 plastic washers M6, 10 philips truss screws M6 x 12 and 4 round clamp spacers (2" long)
INSTALLATION INSTRUCTIONS
POLARIS RANGER 400
REAR WINDSHIELD
PART # 2732
DEALER
DESCRIPTION
CNC rear windshield cut-out made of ⅛" thick GE polycarbonate or equivalent
Includes : 3 male clamp parts and 3 female clamp parts
Includes : 2 male clamp parts and 2 female clamp parts
Socket cap
screw M6 x 20
Male clamp
spacers
part
Coupling
nut M6
Female
clamp part
Male clamp part
Nylon locknut M6
Socket
cap screw
Clamp
M6 x 20
Female
clamp
part
Coupling
nut M6
www.kolpin.com
QTY
1
2
1
1
Coupling nut M6
Socket
cap screw
Male
M6 x 20
clamp
part
1