Inspection And Maintenance - OTC Motor-Rotor 1735B Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Parts List & Operating Instructions

CAUTION: To prevent personal injury,

•

Only qualified personnel shall perform inspections and repairs to this repair stand.

•

Do not use your fingers to apply grease to the gear box assembly; fingers can easily be

caught in the worm gear.

Inspection

Before each use, an approved inspector must inspect the

repair stand for bends, cracks, dents, elongated holes, or

missing hardware. If damage is found, discontinue use.

Maintenance

1. Periodically grease the zerk (Item 36 in the parts list) on

the rotating shaft located on the inner post.

2. Periodically clean the wheels and casters, and apply a

low-temperature grease.

3. Keep the worm gear assembly well lubricated. Brush

Molykote

-type GN paste into the gear assembly from the

bottom of the housing while rotating the gear box.

4. Use only those repair parts called out in the parts list in this

document. Items found in the parts list have been carefully

tested and selected by US Service Solutions LLC.

Adjusting the Worm Gear Assembly

Periodic adjustment of the worm gear assembly may be

necessary due to wear or replacement of parts. To remove

free play from the worm gear assembly:

1. Remove all weight from the repair stand.

2. Loosen the small socket head set screw (see Figure 4).

3. Turn the large socket head set screw clockwise until there

is no free play. Torque the large socket head set screw to

8 N•m (70 in. lbs.).

4. Tighten the small set screw.

5. Rotate the crank handle until the support plate has been

rotated one complete turn.

6. Place a torque wrench on the crank handle nut as shown

in Figure 5. The torque required to move the handle should

be no more than 7 N•m (60 in. lbs.).

Disposal

At the end of the useful life of the repair stand, dispose of

repair stand components according to local regulations.