OTC Motor-Rotor 1735B Mode D'emploi page 3

Parts List & Operating Instructions
28
27
1. Use 3/8-16 UNC x 88.9 mm (3.5 in.) cap screws to securely bolt the rear axle (Item 32) to lower frame (18).
2. Place a wheel lock (30) on each axle, with the knurled portion of the wheel lock facing toward the wheel.
Slide a wheel (29) onto each axle, and secure with a washer (28) and self-locking nut (27).
3. Use 3/8-16 UNC x 25.4 mm (1.0 in.) cap screws to fasten the swivel casters (23) to the front of the lower frame.
4. Use 1/2-13 UNC x 101.6 mm (4 in.) and 1/2-13 UNC x 38.1 mm (1.5 in.) cap screws to securely bolt the
inner post (35) to the lower frame assembly.
5. Use 5/8-11 UNC x 44.5 mm (1.75 in.) cap screws to securely bolt the plate (7) to the mounting plate (6).
6. Use 1/2-13 UNC x 101.6 mm (4.0 in.) cap screws to bolt the outer post (12) to the lower frame.
7. Use a 1/4 x 57.2 mm (2.25 in.) roll pin to assemble the support plate (10) to the rod (11). Insert this assembly
into the outer post (12).
8. Position the handle (8) as shown, and secure it to the shaft with the 12.7 mm (.50 in.) diameter self-locking
nut and washer.
© Bosch Automotive Service Solutions LLC
8
35
30
29
Assembly Instructions
Item numbers in parentheses refer to the graphic on this page.
6
32
Form No. 565726
7
10
12
18
23
Sheet No.
2 of 5
Issue Date: Rev. B November 5, 2013
11