Flame Adjustment; Cleaning Your Appliance - BLAZE BLZ-PBLTE Guide D'utilisation Et D'entretien

If the burner does not light after five seconds, turn the control knobs to the OFF position.
5.
Wait five minutes until the gas clears before attempting to light it again.
6.
If the burner does not light after several attempts, immediately close all gas valves and consult an
7.
authorized service technician.
Before cooking with your appliance for the first time, burn off any foreign matter and rid the unit of any odors
by burning the main burners only on HIGH for about 10 minutes.

Flame Adjustment

a. Become familiar with the safety instructions at the front of this manual. Do not smoke while lighting
the appliance or checking the gas supply connections.
b. Make sure that all gas connections are securely tightened and have been leak-tested with a
soapy water solution – never with a flame!
c.
Turn burners to low flame setting and test for proper flame height. Flame should be stable and
burning out of each burner port without danger of going out in the lowest setting.
LOW flame setting simply light the appliance on the LOW setting and adjust the screw
located under the knob on the front of the valve using a flat head screwdriver as seen in
the diagram below.)
NOTE: Always wait until your appliance is completely cool before cleaning. You should clean your appliance after
each use to maintain the overall appearance over the life of your appliance. After the first use, it is normal for
your appliance to become discolored in certain areas from the heat produced by the burners.
Exterior Cleaning
When cleaning your appliance, always scrub and polish in the direction of the stainless steel grain. Wipe down

Cleaning Your Appliance

BLAZE Instructional Book
Low flame setting
screw
Page | 32
(To adjust the