examples of the more common configurations found. Notice the middle set of vents being
positioned lower on the island cavity for LP gas.
ALL GAS CONNECTION POINTS SHOULD BE TESTED FOR LEAKS AFTER
INSTALLATION PRIOR TO FIRST USE OF THE GAS APPLIANCE(S).
Before installing an appliance in any island cut out, make sure that the opening is not bigger than the outside
frame of the appliance unit. The appliance should rest on the lip of the frame.
Pay careful attention to the location of the gas line. It should be routed away from sources of heat, sharp edges
and aggressive surfaces and should make as few bends as possible.
Ensure the gas line connection will be accessible when appliance is installed. A safety shutoff valve is required at
this gas connection point.
The burner must be double checked for the correct placement in the appliance before operation. When finished
ensure that the burner i s aligned in the bracket slot. Failure to do so could result in a fire and injury.
If the outdoor kitchen countertop will overhang the face of the island, notching out the two front countertop edges
will be necessary to allow the double burner to slide flush against the outer front wall to the outdoor kitchen. Due
to differing personal preferences of the size of the notch out, this is recommended to be done at the point of
installation so that the consumer can dictate their preference.
Slide the appliance into the cut out and then attach the gas line.
•
BLAZE Instructional Book
Page | 27