Gas Safety And Installation Warnings - BLAZE BLZ-PBLTE Guide D'utilisation Et D'entretien

Be certain your appliance is properly installed and grounded by a qualified technician in accordance with
applicable codes. To guarantee the electrical safety of this appliance, continuity must exist between the
appliance and an effective grounding system. It is imperative that this basic safety requirement be met.
The manufacturer cannot be held responsible for damages caused by the lack or inadequacy of an
effective grounding system.
Do not operate any appliance with a damaged power cord or power plug, and do not operate any
appliance after the appliance malfunctions or has been damaged in any manner. If this should occur, return
the appliance to the nearest authorized service facility for examination, repair or adjustment.
This appliance conforms to all uniform electrical safety codes and electrical grounding regulations. Install
unit according to I.A.W. local codes or with National Electrical Code ANSI/NFPA 70 or CSA C22.1 in their
absence.

Gas Safety and Installation Warnings

All gas connections should be made by a Professional qualified technician and in accordance with local
•
codes and ordinances. The installation must conform with local codes or, in the absence of
local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or CAN/CGA-B149.1,
Natural Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code.
Always check the Rating Plate to make sure the gas supply you are hooking up to is the gas
•
type the appliance is manufactured for.
Check the rating label on the left hand outside of the burner.
•
Do not twist the gas supply hose.
•
Before each use, visually inspect the gas supply hose for cracks, cuts or excessive wear.
•
Replace the hose if necessary. Check for gas leaks before each use.
Gas Specifications: Be sure that the gas supplied to the appliance conforms to the model you
•
purchased. A Natural Gas appliance requires natural gas to operate; an LP appliance requires liquid
propane gas to operate.
Never connect the appliance to an unregulated gas supply line. Appliances operated without a
•
RATING PLATE LOCATION
BLAZE Instructional Book
Page | 13