Installation Instructions - ClassicFlame Insert 18EF010GAA Manuel D'instruction

Masquer les pouces

Table des Matières

Les langues disponibles

Position your completed Wood Mantel close to its

final location. Make sure you can access the back of

the Fireplace, as your Electric Fireplace Insert will be

installed from the back.

Using a Phillips head screwdriver, remove the screws

and the metal mounting brackets attached on either

side of the fireplaces center opening. Next unpack

the Electric Fireplace Insert carefully. Position insert

behind fireplace with front facing the wood mantel.

With the help of an adult assistant, lift the Insert and

gently slide it into the opening in the mantel until the

flange is flush against the inside of the fireplace. Make

sure insert is centered left and right in the opening. Be

careful when placing insert and adjusting, bottom of

insert could scratch the finish of the wood base/hearth

of your fireplace. Re-attach the mounting brack-

ets with the Phillips head screwdriver, and supplied

screws. DO NOT OVER TIGHTEN.

With the help of an assistant, carefully lift completed

unit and place it with the front facing out in the final

location you have chosen

sure to secure the electrical cord before lifting or mov-

Part Name

Emberbed

Heater/Blower Assembly

Mechanical Thermostat Switch

Knob for Heater Temperature control

Brightness Dimmer Switch

Knob for Brightness Control

Main Power Switch – Red Toggle

Heater On/Off Switch – Red Toggle

E-12 Light Bulb Sockets

Control Panel Circuit Board

Circuit Board - 3 Buttons Remote

Front Projection Screen

Flame Generator Drive Motor

Flame Generator/Spinner

Decorative Brick Panels

Remote Control - 3 Buttons