Aeronaut Lilienthal 40 RC Mode D'emploi page 3

Lilienthal 40 RC
Lilienthal 40 RC is an ideal first model. The concept includes a free flying model with a timer-
operated dethermalizer as well as an RC option for rudder and elevator. Small components
keep the increase in weight to a minimum and make Lilienthal a docile model for light wind
conditions. Precisely laser-cut parts, simple construction and the use of a special wing jig make the building
process fast and easy. Detailed building instructions with graphics and text explain every single building
step and answer all the questions you might have, so that even less experienced modellers or beginners
will be able to complete the model. Tips for your first flight as well as advice for trouble shooting complete
the manual. Construction should be according to the step-by-step instructions in this manual. Use a sharp
modelling knife to cut individual parts from laser sheets. Always check that parts fit perfectly and correct, if
necessary, before you glue. Please note recommendations below for gluing the various materials in this kit.
Attention: Give glue sufficient time to dry before you begin with the next step.
Recommended equippment for RC option
small and lightweight RC components
4-cell NiMH battery, 300 mAh
2 Servos AN-8-HBA Order No. 7003/70
Recommended glues
Material
wood/wood
wood/CfK
wood/plastic
Recommended wood treatment
Material
Holz
Glue (Order No.)
Ponal Express (7638/10), UHU hart (7631/02)
Ponal Express (7638/10), UHU hart (7631/02)
Ponal Express (7638/10), UHU hart (7631/02)
Treatment Order No.
Porenfüller 7666/02
Laser-cut parts are retained in laser sheets
by means of small tabs. Use a sharp
modelling knife to cut the tabs. Do not
remove parts by hand to avoid
damage to parts!
We recommend our
modeller´s knife
Order No. 8185/00
For building we recommend
our aero-pick modeller´s pins
Order No. 7855/02
Drive set incl. motor, speed controller
and propeller
Order No. 7126/01
fits to your model which needs to be
equipped with remote control system.