Digital multimeter
7.6 Audible continuity test
(1)
Connect red test lead to "V. .mA", black test lead to "COM".
(2)
Set range switch to
tested. If continuity exists, built-in buzzer will sound.
8.
BATTERY & FUSE REPLACEMENT
• If "
" appears on display, it indicates that the battery should be replaced.
• Fuse rarely need replacement and blow almost always as a result of operator's error.
• To replace battery fuse
-F1:FF 250mA H 600V, 10KA
-F2:FF 10A H 600V, 10KA
• Remove the 2 screws in the bottom of the case. Simply remove the old, and
replace with a new one.
• Be careful to observe battery polarity.
Before attempting to open the case, always be sure that test leads have been dis-
connected from measurement circuits. Close case and tighten screws completely
before using the meter to avoid electrical shock hazard.
9.
ACCESSORIES
• Operator's instruction manual
• Set of test leads
• 9 volt battery. NEDA 1604 6F22 006P type
• Holster
and connect test leads to two points of circuit to be
WARNING
15