Orbegozo PB 2232 Manuel D'instructions page 13

PB 2232
Remarks: This initialization process as below must be repeated if the scale is moved. At
all other times step straight on the scale.
Step 1. Press the platform centre and remove your foot.

Step 2. "0.0" will be displayed

Step 3. The scale will switch off and now it is ready for use.

This initialisation process must be repeated if the scale is moved. At all other times
step straight on the scale.
Step 4. Gently step on the scale. Put your feet evenly on the scale without

moving and wait whilst the scale compute weight. Your correct weight will then
be displayed in the following way: 80.3 Kg.
Body Fat Measurement:
In order to ensure accurate results users should enter the required personal
parameters:
age, sex and height.
These scales have the facility to store the personal parameters of 10 people.
The technology used in these scales, Bio-electrical impedance Analysis (BIA)is more
technologically advanced than the older Body Mass Index (BMI) method where fat % is
calculated using only height and weight. BIA technology uses 5 parameters to get a
more accurate resolution for the analysis (weight and biological resistance which are
automatically measured by the scales together with the three personal parameters
entered manually).
Mode selection and parameter setting:
Step on the scale platform to switch on
Press UP or DOWN to switch between Body Parameter 0-9. Press SET to confirm.
Press UP or DOWN to select male or female. Press SET to confirm
Press UP or DOWN to indicate height Press SET to confirm
Press UP or DOWN to indicate age. Press SET to confirm
The values are flashed and recorded.
13