Swarovski COSMIC ROCK Mode D'emploi page 83

Accumulated timing
To measure the combined time of a series
of shorter events
Push button D to start the chronograph.
01
Push button D to stop the chronograph
02
and read the elapsed time.
Push button D to resume measurement.
03
Repeat steps 2 and 3 to add each
interval of time.
To reset the chronograph hands
04
(F, G, and L) push button E.
Intermediate or interval timing
To take intermediate time readings as
an event progresses
Push button D to start the chronograph.
01
Push button E to read the first
02
intermediary time. The chronograph will
continue to operate.
Push button E again and the chrono-
03
graph hands (F, G, and L) will catch up
with the elapsed time. Repeat steps 2
and 3 to take any additional split times.
To display the total elapsed time push
04
button D
To reset the chronograph hands (F, G,
05
and L) push button E.
Adjusting the chronograph (counter)
hands to Zero position
When one or several chronograph hands
are not in their correct zero positions
— Pull out the crown to position C and
press the upper and lower push-
buttons (D and E) simultaneously until
the seconds counter (G) rotates
360° (corrective mode is activated).
Adjusting the 60 seconds counter (G)
— Push button D until the hand is set to
zero.
— To adjust the next hand, push button E
once
Adjusting the hour counter (L)
— Then push button D until the hand is set
to zero.
— To adjust the next hand, push button E
once
83