Design And Function; Overview - CASO DESIGN FW2000 Mode D'emploi

 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.

16 Design and Function

In this chapter, you'll find important information on the design and function of the device.

16.1 Overview

10 cutting plate medium (5mm)
12 fixing ring
11 cutting plate coarse (8 mm) 15 cutting plate fine (3 mm)
13 sausage accessory 14 dough accessory with pattern
1 motor unit
2 switch (REV,
OFF, 1, 2)
3 locking handle
4 tube inlet
5 pusher
6 hopper plate
7 head tube
8 snake
9 blade
31