Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Installation/Commissioning
•
This product can only be installed by a qualified electrician.
•
The connection lines in the building must be disconnected before installation and secured against being
switched back on. For this, trip the corresponding fuse switch in the building installation.
•
Make sure that the foundation is suitable to support the weight of the LED-Spotlight, permanently and
reliably.
•
Saw out the installation dimensions at the desired site. Use the permanently assembled holding clips to
fasten the LED Spotlight. Make sure that no connections are damaged.
•
Now wire up the connection lines of the building installation at the screw terminals of the
light/transformator. The brown (or black) cable is usually the phase conductor. Connect this to the
terminal marked with an "L". The blue conductor must be connected to the terminal marked with an "N".
•
Do not bend the cable; make sure that the cable and the plug are free from any tractive and torsional
forces. Protect all cables and insulations from any possible damage.
•
Check the proper connections once again.
•
Switch the building installation's fuse switch back on.
6. Faulty Function
Light does not switch on
•
Light switched on at the wall switch?
•
Check the connected lines
7. Technical Data
Article
Port / installation diameter
Input 220V-240V AC, 50 ~ 60
500665
Hz 43mA, Ø72mm,
Input 220V-240V AC, 50 ~ 60
500666
Hz 43mA, Ø72mm,
Input 220V-240V AC, 50 ~ 60
500667
Hz 43mA, Ø72mm,
Input 220V-240V AC, 50 ~ 60
500668
Hz 43mA, Ø72mm,
500665
Plastic white, Ø82mm, 5W, 380lm,
3000K, swiveling, 3-step dimmable
Plastic nickel matt Ø82mm, 5W, 380lm,
3000K, swiveling, 3-step dimmable
White plastic, Ø82mm, 5W, 380lm,
3000K, rigid, 3-step dimmable
Plastic nickel matt Ø82mm, 5W, 380lm,
3000K, rigid, 3-step dimmable
500666
500667
Protection
Light
500668
Protection
Type
Class
IP20
II
IP20
I
IP44
II
IP44
II
2 of 3 | dated 12/2019
Publicité
Table des Matières
