Safety Instructions/ Warnings; Proper Use - Heitronic 500665 Instructions D'installation Et D'utilisation

GB Installation and Operating Instructions
LED Spotlight
Art. No. 500665, 500666, 500667, 500668
These operating instructions refer exclusively to these products.
They contain important information for the start-up and handling of the light.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The light fulfils the requirements of effective European and national guidelines
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions/ Warnings

•
In the event of damage which is caused by not following these operating instructions, the warranty is
rendered void!
•
We do not accept liability for any consequential damage!
•
Commissioning is strictly prohibited if there are any damages to the light!
•
The light may become hot during operation.
•
The built-in spotlight must not be covered under any circumstances whatsoever with thermally
•
insulating coverings or similar materials.
•
The product in its entirety must not be altered or modified. Alterations to the light invalidate the
guarantee.
•
The type plate must not be removed.

3. Proper Use

The light is designed for use in indoor/and outdoor areas.
This product is only intended for lighting purposes and may:
•
only be operated with a voltage of 230V ~50Hz
•
only be connected according to protection class II (two)
•
only be operated when mounted to a sturdy, level and non-tilting surface.
•
only be operated on normal or non-flammable surfaces
•
not be subjected to strong mechanical loads or heavy soiling.
4. Before Installation/Commissioning
•
The light may only be operated once removed from the packaging.
•
Remove the light from the packaging carefully.
•
Make sure that the light has not been damaged during transport before putting the light into operation.
The light may not be operated if there are any damages to electrical parts. Repairs may only be carried
out by a qualified electrician.
•
Keep packaging materials away from children and pets. Asphyxiation hazard!
1 of 3 | Dated 12/2019