Pro-User APB120 Mode D'emploi page 9

NOTE: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN IMAGE MAY TAKE A
FEW SECONDS TO STABLIZE. PLEASE WAIT UNTIL THE IMAGE HAS STABLIZED BEFORE
BACKING UP.
Back up System testing
1 Reattach the vehicle's negative battery cable.
2 Turn the ignition key to the accessory position, do not start the vehicle.
3 Engage the parking brake, and then put the shifter in the reverse position.
After testing the unit and you are satisfied with the route you have chosen for the cabling,
you must permanently install it.
Route all wires behind interior panels or under carpeting so they are hidden. Use supplied
cable ties to neatly gather any excess wire.
OPERATION
The built-in LCD display beneath the mirror will automatically turn on and enter back up
mode when the vehicle is in reverse gear, otherwise, the device will turn into Bluetooth
hand free mode, in Bluetooth mode, if no mobile device was found in 30 sec, system will
enter sleep mode.
There are 8 control buttons and a volume dial available for users to have their controls:
Power on/Sleep button
Press the POWER button to supply power to the mirror. When the mirror image is on, the
yellow LED (beneath the power button) will be off. If there is power to the mirror, but the
mirror image is OFF, the yellow LED will on. When the monitor power is off, no picture
can appear on the screen and the yellow LED will be off as well.
8