Programming With Smart Cd; Programming With A Pc Or Laptop - Simons Voss Technologies SmartCD.G2 Guide Abrégé

SmartCD.G2


Carry out the following additional steps to use SmartCD with a PDA:




6 Programming with Smart CD

During programming, there should a minimum gap of around 10 cm
between SmartCD and the locking device; for SmartRelay it should be
around 30 cm and 70 cm for the block lock.

6.1 Programming with a PC or laptop

The current version of the Locking Data Base 1.50 a software or higher,
or Locking System Management (LSM) 2.2 or higher should be installed
on the PC or laptop. A programming device needs to be connected to
the PC or laptop for a new software installation or update.
EN
Install LSM software. The required drives for SmartCD.G2 are
installed automatically for LSM 3.3 and above.
Connect SmartCD.G2 to the USB port on the PC or laptop.
Install the SmartLSM locking plan software using ActiveSync on the
PDA.
Interconnect SmartCD.G2 and PDA via Bluetooth (use the
SmartLSM to do so).
Set COM port on the PDA to SmartCD.G2 (use the SmartLSM to do
so)
6. Programming with Smart CD
25 / 104