Publicité
Center cross bars and attach
10
SkyLine or Control Towers to
crossbars according to your
SkyLine or Control Tower
instructions.
While holding the SkyLine or Control Tower above the
12
Landing Pad, fully tighten Landing Pad to 1.5 Nm (13.3
in lb) (use the long end of the wrench as shown).
Repeat the process again for the
other Landing Pads to ensure
they have not changed position.
Re-insert SkyLine or Control
Tower into the Landing Pad, fully
tighten tower (refer to tower
instruction) and close cover.
DO NOT OVER TIGHTEN AS DAMAGE
TO THE ROOF MAY OCCUR.
14
READ THESE WARNINGS!
MAKE SURE SKYLINE
OR CONTROL TOWERS,
WITH BARS INSTALLED,
SEAT COMPLETELY WITH
LANDING PAD. IF THEY
DO NOT SEAT PROPERLY,
REPEAT STEPS 9-12.
Continue with SkyLine or Control Tower installation.
Instruction #1036055B-4/9
•
BE SURE ALL HARDWARE IS
SECURED ACCORDING TO
INSTRUCTIONS. FAILURE TO
PERFORM SAFETY CHECKS BEFORE
DRIVING AWAY CAN RESULT IN
PROPERTY DAMAGE, PERSONAL
INJURY, OR DEATH.
•
ATTACHMENT HARDWARE CAN
LOOSEN OVER TIME. CHECK AND
TIGHTEN IF NECESSARY, BEFORE
EACH USE.
•
TO AVOID DAMAGE YOUR VEHICLE'S
FINISH REMOVE AND CLEAN
LANDING PADS AND MOUNTING
POINTS PERIODICALLY AS ROAD
SEDIMENT WILL ACCUMULATE
OVER TIME.
Open one SkyLine or Control Tower
11
cover, and lift it up while the opposite
tower is still engaged.
1.5 Nm (13.3 in lb)
4X
To review your vehicle's
specific weight limit and load
limitations for accessories,
visit.yakimatech.com.
For additional product support,
visit yakima.com/support or
contact us directly at (888)925-
4621 Monday through Friday,
7:00 AM to 4:00 PM, PST.
Install covers
13
when rack is not
attached.
4X
USING THE COVERS WILL
HELP KEEP THE BASES
FREE OF DEBRIS.
DO NOT EXCEED
MAXIMUM WEIGHT LIMIT
FOR YOUR VEHICLE.
Publicité
