System Features - Dell PowerEdge T105 Systems Guide De Mise En Route

System Features

This section describes the major hardware and software features of your
system. It also provides information about other documents you may need
when setting up your system and how to obtain technical assistance.
• One dual-core or quad-core AMD™ Opteron™ 1000 processor or AMD
Sempron™ with ECC processor (when available).
NOTE:
See the Hardware Owner's Manual.
• A minimum of 512 MB of 667- or 800-MHz DDR II SDRAM memory,
upgradable to a maximum of 8 GB DDR II SDRAM memory by installing
512-MB, 1-GB, or 2-GB unbuffered ECC memory modules in the four
memory module sockets on the system board, single- or dual-rank.
• Support for the following internal hard-drive (non–hot-plug)
configurations:
– Up to two internal 3.5-inch SATA hard drives with an integrated SATA
controller
or
– Up to two internal 3.5-inch Serial-Attached SCSI (SAS) hard drives
with a SAS controller card
• One 3.5-inch peripheral drive bay for the optional diskette drive, and
two 5.25-inch bays for the following supported drives: DVD-ROM,
combination CD-RW/DVD, DVD-RW, or tape backup device.
NOTE:
• Support for the following RAID volumes with an optional SAS RAID
controller card: simple, spanned, striped (RAID 0), and mirrored (RAID 1).
• Support for USB 2.0.
• A chassis intrusion alert.
Use the System Setup program to view processor information.
DVD devices are data only.
Getting Started With Your System
5