GE Profile GLD3866T05SS Manuel Du Propriétaire page 8

About the dishwasher control panel.
choose the dishwasher control panel that corresponds to the features on your dishwasher.
control settings
Status Indicator lights
1
The Status display tells you what's happening while the dishwasher is in operation and may flash, indicating a
malfunction (see page 6). The lights will come On indicating the sequence of operation the dishwasher is in.
LOW DETERGENT Displayed when the SmartDispense
(on some models)
SENSING
WASHING
DRYING
SANITIZED
CLEAN
Time remaining display
2
During operation, the display shows the minutes remaining until the cycle is complete. The display may adjust
the remaining time while the Sensing light is on. The time displayed at the start of each cycle may change from
the factory setting as the unit customizes itself to home use. During a delay start, the display will show hours of time
remaining until the cycle starts.
Cycles
3
Press the pad for the desired wash cycle.
NOTE: All cycle times and water usage information contained in the following section are approximate
values only. Actual results will depend on several factors, including but not limited to, inlet temperature,
household water pressure and turbidity of the wash water.
The light above or next to the selected pad will be On to indicate which WASH CyClE has been selected.
SANI WASH
POTS & PANS
NORMAL WASH
LIGHT WASH
(on some models) This cycle is for everyday dishes and glassware.
8
1 6
3 5
dishwasher detergent.
Displayed while the ExtraClean™ Sensor is measuring the amount of soil and temperature
of water. The dishwasher will adjust the selected cycle to achieve optimal performance.
Displayed during prewash and main wash periods.
Displayed during HEATEd dry.
Displayed when cycle has met sanitization conditions. Light remains On until door is opened.
Displayed when a wash cycle is complete.
(on some models)
7.5–8.75 gal., 50–135 min.
This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle
length will vary depending on the temperature of your inlet water.
NOTE: The SAnI WASH cycle is monitored for sanitization requirements. If the cycle is interrupted
during or after the main wash portion or if the incoming water temperature is so low that
adequate water heating cannot be achieved, the sanitizing conditions may not be met. In these
cases, the Sanitized light will not illuminate at the end of the cycle.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
8.75–10 gal., 75–140 min.
This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-on soils.
This cycle may not remove burned-on foods. Everyday dishes are safe to be used in this
cycle.
5.2 gal., 60–90 min.
This cycle is for medium/heavily soiled dishes and glassware.
7.5 gal., 40–60 min.
4
needs to be refilled with liquid or gel automatic
TM
2