SuperFish Pond-Flow eco 1000 Mode D'emploi page 3

Installation
Cut the hose connector (B) to the desired diameter and fasten this to the pump (A). Connect the
pond hose to the hose connector using a hose clamp (not supplied).
Install the pump in your pond at least 20 cm below the surface of the water. Make sure that the
pump is seated firmly. Never put the plug down in wet grass or on wet ground.
Remove the pump from your pond during frosty periods and store it somewhere free from frost,
preferably in a tank filled with water.
Dismantling/Assembly
The SuperFish Pond-Flow requires virtually no maintenance. If you nevertheless want to clean the
pump or dismantle it for any other reason, first of all unplug the equipment. You can then remove
the pump from the pond, disconnect the hose, and dismantle the connector with the hose
connection.
Technical data
SuperFish Pond-Flow
Voltage
Power
Capacity
Max. head of water
Connection
Cable length
1000
220-240 V/50 Hz
12 W
1,000 l/h
1.40 m
32/25/20 mm
10 m
2000
220-240 V/50 Hz
25 W
2,000 l/h
1.90 m
32/25/20 mm
10 m
3000
220-240 V/50 Hz
45 W
2,900 l/h
2.30 m
32/25/20 mm
10 m
3