Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Install Hitch and Bumper beam - Use silicone sealant to seal around the opening on the end panel both sides. Raise hitch and bumper beam into position aligning
holes with studs in end panel. See Figure 1. Loosely reinstall the (6) existing M10 hex flanged nuts removed in step 3, onto the studs in end panel. Tighten all M10-1.25
CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Bumper beam
Existing M10 Hex Flange Nut
(6) Places
5. Trim fascia –Locate the center of the fascia. Using a tape measure, marker, and utility knife, cut a notch in the bottom of fascia.
See Figure 3 for Chevy Trailblazer and Figure 4 for Buick Encore GX for the dimensions of trimming area. Note: Be sure area is clear of all electrical wiring before
trimming.
Area to trim
©2022 Horizon Global™ Corp - Printed in Mexico
Proper torque is needed to keep the hitch secure to the vehicle
when towing.
End panel
Figure 1
Trailblazer
C L
4"
3-5/8"
Figure 3
Existing M10-1.25 Stud
(6) Places
Silicone sealant areas
Area to trim
4"
Sheet 7 of 27
Encore GX
C
L
4"
Figure 4
76585NP
3-18-22
Rev. A
Publicité
Table des Matières
