Installation Instructions - cosi cube 70 Manuel D'utilisation Et D'installation

2. Installation instructions

The Cosicube is supplied complete with pressure regulator (30 mbar) and gas hose. You only need to purchase
a propane gas bottle. These can be purchased at your local gas supplier.
1. Installing the Cosicube
Get your Cosicube carefully from its packaging. Select the location for your Cosicube.
The location must meet the following conditions:
- Make sure that the Cosicube is placed on a paved (preferably stone) surface.
The surface should be completely flat and clean.
- The Cosicube should be placed at least two meters away from flammable
materials and liquids.
- After placing the frame on a stable surface, you can place the burner into the
recess in the table top (see image on the right).
Before the Cosicube is ready to use you have to place an AAA battery for the piezo
ignition. Please see '2.5 Replacing the battery for the piezo ignition'.
When the Cosicube is installed properly, you can place lava rocks and ceramic logs on the top. Every Cosicube is
supplied with small and large lava rocks. Take the small lava rocks without grit and place these gently on the
model. Repeat the process with the big lava rocks and make sure the burner is covered with lava rocks. Keep the
space around the ignition unit free of lava rocks (see image below).
After placing the lava rocks, unpack the ceramic logs. The Cosicube is always supplied with four pieces, you can
place the ceramic logs as a camp fire over the burner ring. It is recommended to place the ceramic logs as follows:
Ignition unit
Keep the space around the ignition unit free of lava rocks. Make sure the fire ring and ignition unit are only
minimally covered by the logs. If the logs block the fire ring, dangerous situations may occur. The blockade of the
fire ring will affect the air flow of the ring and the flames will be different. This results in dangerous situations!
If you want to order more lava stones or ceramic logs, this is possible at your purchase address.
Pay Attention: When you are going to use the Cosicube for the first time, make sure that the device is turned at
the highest setting for 15 minutes. In this way, the lava stones are heated through and this ensures that any
bumps or air bubbles will disappear from the lava rocks. During the first time the Cosicube is turned on or when
the lava rocks have been wet (after some rain), keep at least two meters away from the burner and also ensure
that no flammable materials are placed around or on the table within this radius of two meters. Because the
air bubbles are burned from the lava stones, the stones can jump up during the first time / when lava rocks have
been wet and possibly come out of the burner.
When you want to move or clean up the lava rocks and ceramic logs, always make sure that they have cooled
down completely.
13