Installation Description - DigiTrace RAYSTAT-CONTROL-10 Mode D'emploi

During the time that the actual measured temperature is shown in the
value display, the X
When the set point temperature is shown, the W
play lights up.
Also during normal operation, the middle horizontal LED in the status dis-
play lights up for the time that the heater (main relay) is ON (
For example:
switched on,
switched on.
2. In case an error is detected, the value display shows "
and the status display indicates the error number (see Errors).
3. Programming is done by means of the push buttons (see Operational de-
scription). In the programming mode, the status display will indicate the
code of the parameter that is selected. The value display indicates the
value for the parameter.
4. When power is initially applied, all display segments will illuminate for a
short period. This will also occur if no mains power is available and the
battery button is pressed. Do not push the battery button when the unit is
powered, as this will shorten battery life.

Installation description

1. Installation of heating cable
For design and selection of heating cables in sanitary applications, follow the
Technical Handbook.
For selection of industrial heating cables, follow the Selection Guide for In-
dustrial Trace-Heating Systems or use the latest version of TraceCalc or con-
tact your Tyco Thermal Controls representative.
Follow the design guidelines and install the system in accordance with the
system specifications.
Follow the "Product Safety Notice" supplied with the heating cable.
Residual current device (RCD 30 mA) is required.
The RAYSTAT-CONTROL-10 is a sensitive electronic device, and should be
installed taking care of common guidelines for EMC interference.
8
LED in the status display lights up.
T
means 20°C measured temperature and heater is
means set point temperature 24°C and heater is
LED in the status dis-
T
" (flashing)
).