DigiTrace RAYSTAT-CONTROL-10 Mode D'emploi page 13

3. Parameters
The first parameter to show up during Set-up mode is the Set Point. Other
parameters, their default, minimum and maximum values are shown in the
below table:
Parameter
Set Point (°C)
Hysteresis (K)
Low Temperature Alarm
1
Threshold (°C)
High Temperature
Threshold (°C)
Heater Operation if
Sensor Error
Voltage Free Operation
1
Max. Low Temp. Alarm is always smaller than Set Point minus hysteresis.
2
Min. High Temp. Alarm is always larger than Set Point plus hysteresis.
3
Consider also max. exp. temp. of heating cable in table,to select an
appropriate High Temp. Alarm value. If one does not want the High Temp.
Alarm to be active, set the value to
Default Displayed
Value Code
5
1
0
65
1
0
, which comes after 150.
Min. Max.
0 150
1 5
–40 148
2
2 150
0 (OFF) 1 (ON)
0 (NO) 1 (YES)
1
3
13