Main Components - Grouw 18047 Manuel D'instructions

Main components

1. Carrying handle
2. Hose coupling
3. Suction inlet
4. Float switch
5. Handle for suspending submersible
2
pump on water butt
Installation
5
The submersible pump is designed for use in
GB
water butts, for moving water in the home,
for example, in the garden, greenhouse and
as a cellar pump for � ood protection. There
must be suffi cient space around the pump
for the � oat to move freely. The installation
location must be at least 40×40×50 cm.
Place the pump in the required location and
then plug it in.
The pump must be on a level surface, so
that there is no risk of it tipping over while in
operation.
The pump can be fully or partially
submerged in water. Tie a piece of rope
around the carrying handle, if necessary,
1
4
before submerging in deep water, and also
check that the cord is long enough for the
water depth.
The pump must not be left suspended by its
cord or hose.
If you are using a collecting vessel, you
should check that it is large enough to hold
the pumped liquid, so that it is not necessary
to interrupt operation of the pump.
3
19