Air Supply And Connections - Bostitch BTFP71917 Manuel D'instructions Et D'entretien

Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as
tool may explode, possibly causing injury.
FITTINGS:
Install a male plug on the tool which is free flowing and which will release air pressure from the tool when disconnected from the supply
source.
HOSES:
Air hoses should have a minimum of 150 p.s.i. (10.6 kg/cm
produced in the air system. The supply hose should contain a fitting that will provide "quick disconnecting" from the male plug on the tool.
SUPPLY SOURCE:
Use only clean regulated compressed air as a power source for this tool. NEVER USE OXYGEN, COMBUSTIBLE GASES, OR BOTTLED GASES, AS A
POWER SOURCE FOR THIS TOOL AS TOOL MAY EXPLODE.
REGULATOR:
A pressure regulator with an operating pressure of 0 - 125 p.s.i. (0 - 8.79 kg/cm
operation of this tool. Do not connect this tool to air pressure which can potentially exceed 200 p.s.i. (14 kg/cm
burst, possibly causing injury.
OPERATING PRESSURE:
Do not exceed recommended maximum operating pressure as tool wear will be greatly increased. The air supply must be capable of
maintaining the operating pressure at the tool. Pressure drops in the air supply can reduce the tool's driving power. Refer to "TOOL
SPECIFICATIONS" for setting the correct operating pressure for the tool.
FILTER:
Dirt and water in the air supply are major causes of wear in pneumatic tools. A filter will help to get the best performance and minimum wear
from the tool. The filter must have adequate flow capacity for the specific installation. The filter has to be kept clean to be effective in providing
clean compressed air to the tool. Consult the manufacturer's instructions on proper maintenance of your filter. A dirty and clogged filter will
cause a pressure drop which will reduce the tool's performance.

AIR SUPPLY AND CONNECTIONS

) working pressure rating or 150 percent of the maximum pressure that could be
2
Quick Disconnect Plug
) is required to control the operating pressure for safe
2
Quick Connect Plug
-7-
) as tool may fracture or
2