Maintenance Checklist; Service Interval - Bostitch BTFP71917 Manuel D'instructions Et D'entretien

MAINTENANCE CHECKLIST

Maintenance
Inspect trigger performance
Drain condensation from air
compressor tanks and air filters daily
or after each use.
Clean magazine assembly
Clean nose, door, and
contact arm area
Ensure all fasteners remain tight
Check/clean air inlet air filter
Replace no-mar tip
Replace piston/driver assembly
Replace O-rings
Replace bumper
Replace headvalve
Replace engine cylinder
Benefit
Ensure trigger system is in proper
working order
Prevents accumlation of moisture that
can impede tool performace
Prevents accumlation of debris that
could cause a jam
Prevents accumulation of debris that
could cause a jam or malfunction
Prevent loose parts
Maintains proper air flow to engine for
peak performance.
Prevents marks in softwood
applications
Maintains consistent drive quality
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Procedure
Refer to Tool Operation Check section
in this manual
Open drain cock on tanks and air
filters and drain all condensate
Blow clean with compressed air
Blow clean with compressed air
Tighten all fasteners with
appropriately sized hex wrench
Remove end cap and use compressed
air blow gun to blow filter clean.
Replace filter as required.
Remove worn no-mar tip and replace
with a new tip (a spare tip is located on
the magazine)
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
-14-

Service Interval

Daily
Daily
Daily
Daily
Weekly
25,000 Fasteners, or monthly - if used
in dusty location
25,000 Fasteners
150,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
500,000 Fasteners