Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DIMENSIONS
Visor screws
Figure 5
Figure 7
VISOR INSTALLATION INSTRUCTIONS
1.
Remove power from floodlight.
2.
Place floodlight face up.
3.
Carefully align visor with four (4) screw holes at the top of the fixture shown in
Figure 7.
4.
Install screws provided with visor, taking care to not scratch the finish of the
floodlight. Torque to 19 in.-lbs. (2.2 N-m).
5.
Install floodlight per above instructions.
•
Visor catalog number: DSV2.
NOTE: Visor can be installed before or after floodlight has been in operation.
All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy or completeness thereof are not guaranteed. In
accordance with Eaton's Crouse-Hinds Division's "Terms and Conditions of Sale," and since conditions of use are outside our control, the purchaser should determine the suitability of the product for his intended
use and assumes all risk and liability whatsoever in connection therewith.
Visor
With Visor and Guard
With Visor Only
Eaton's Crouse-Hinds Division
1201 Wolf Street, Syracuse, New York 13208 • U.S.A.
Copyright
Figure 4
Wire guard
screws
GUARD INSTALLATION INSTRUCTIONS
1.
Remove power from floodlight.
2.
Place floodlight face up.
3.
Carefully align guard with four (4) screw holes on each side of the fixture shown
in the image above.
4.
Install screws provided with guard, taking care to not scratch the finish of the
floodlight. Torque to 19 in.-lbs. (2.2 N-m).
5.
Install floodlight per above instructions.
•
Wire guard catalog number: P62.
NOTE: Guard can be installed before or after floodlight has been in operation.
2019
©
Guard
With Guard Only
Figure 6
Supersedes 08/17
IF 1828
Revision 3
Revised 02/19
Publicité
Table des Matières
