Cleaning The Brewing Unit; Storing Accessories; Tips On Energy Saving - Bosch Vero Professional TCA71-RW Mode D'emploi

en de
Dismantling the milk system 10 for
cleaning:
Pull the milk system 10 forward out of the
appliance.
Clean the individual parts (Fig. C) with a
detergent solution and a soft brush.
Rinse all parts with clear water and dry
them.
Reassemble all the parts and replace fully
in the appliance.
Note: All the parts of the milk frother 10 can
also be put in the dishwasher.

Cleaning the brewing unit

(refer also to the quick reference guide)
In addition to the automatic cleaning pro-
gramme, the brewing unit 21 should be
removed regularly for cleaning.
Switch to the "energy saving mode" with
a
the button 2.
Switch the appliance off completely at the
power on/off switch 1 O / I; no buttons
are lit.
Slide the door opener 20 to the right and
open the door 19 to the brewing unit 21.
Slide the red lock 21b on the brewing unit
21 completely to the left.
Press the red button 21a, grasp the
brewing unit 21 by the recessed grips
(Fig. E) and remove carefully.
Rinse the brewing unit 21 thoroughly
under running water.
Important: Clean without detergent and do
not place in the dishwasher.
thoroughly with a damp cloth and remove
any coffee residues.
Allow the brewing unit 21 and the inside
of the appliance to dry.
Reinsert the brewing unit 21 fully into the
appliance.
Slide the red lock 21b fully to the right
and close the door 19.
14

Storing accessories

The espresso machine has special com-
partments for storing the accessories and
quick reference guide inside the appliance.
To store the measuring spoon 14, milk
pipe 10d and tube 10c, remove the water
tank 11 and insert the parts in the shaped
recesses 13.
The quick reference guide has its own
compartment by the brewing unit 21.
Open the door 19 to the brewing unit.
Grasp the red cover 23 to the storage
compartment 22 by the tab and remove.
Stow away the quick reference guide,
replace the cover 23 and close the door
to the brewing unit 19.

Tips on energy saving

– The fully automatic espresso machine
switches to "energy saving mode"
automatically after one hour (factory
setting). The appliance uses very little
power in "energy saving mode". The
default time of one hour can be altered:
(see Menu settings, "
– If the appliance is not being used, switch
it off at the power on/off switch 1 O / I on
the front.
– If possible, do not interrupt coffee or milk
froth dispensing. Cutting the coffee or
milk froth dispensing process short
results in higher energy consumption and
in more residual water collecting in the
drip tray.
– Descale the appliance regularly to avoid a
results in higher energy consumption.
a
uto oFF aFter ") .