Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Enclosure Configuration
Cleaning/Replacing Filters
The SR42UBEIS comes with pre-installed dust filters in the front door. It uses standard 18" x 30" filters that can be found at most home improvement
stores. To remove the filters for cleaning or replacement:
1
Slide the filter up into the top filter slot so
that the bottom of the filter is above the
bottom filter slot.
1
Installing the Drip-Resistant Cable Access Housing (Optional)
The SR42UBEIS comes with an optional cable access port housing for drip-resistant cable access at
the top of the unit. To install this feature, please follow these instructions:
1
Remove one of the rubber sealing plugs from the top rear of the enclosure by pushing it out
from inside of the unit
2
Mount the cable access housing using the included M4 x 8mm pan head machine screws and
toothed washers (4 of each). Fasten the screws into each of the threaded holes.
2
Pull the filter away from the door until it is
past the bottom filter slot.
2
10
3
Pull the filter down out of the top filter slot.
3
Publicité
Table des Matières
