Enclosure Configuration; Adding Or Removing Front And Rear Doors; Adding Or Removing Roof Panel - Tripp-Lite Projecteur compact NEMA 12 Guide Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Enclosure Configuration

Adding or Removing Front and Rear Doors

WARNING: Do not attempt to add or remove doors without assistance.
Note: The doors are designed to seal tightly and may require pushing on the top or bottom of the doors to set them properly.
Removing Door
1
Disconnect the door's ground wire.
2
Open the door until it is perpendicular (90 degrees) to the front of the enclosure.
3
Lift the door from the hinges and remove it from the enclosure.
To Reinstall Door, Reverse Steps 1-3
(Optional) If the enclosure is joined to another enclosure, turn the door back toward the enclosure
as you lift it from the hinges.

Adding or Removing Roof Panel

WARNING: Do not attempt to use the roof panel for weight-bearing purposes other than those explicitly described and approved
by Tripp Lite. Do not attempt to add or remove the roof panel without assistance.
Removing Roof Panel
1
Remove the 4 screws (2 on front, 2 on back) that attach the roof panel to the unit.
2
Lift the roof panel from the enclosure.
To reinstall roof panel, reverse these steps
1
2
3
1
2
7
90°

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sr42ubeis

Table des Matières