Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite WallMax™ Cutoff
®
Installation & Operation - Junction Box Mounting:
1. Turn off the power before
beginning installation.
ON
OFF
4. Use screwdriver to remove
the ½" NPT KO plug from
the back of the fixture.
7. Drill through the three (3)
corner mounting holes on
the back plate.
10. Using three (3) anchor
bolts (not included), secure
the back plate to the wall.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
2. Use a Phillips-head screwdriver to
loosen the two (2) screws on the right
side of the fixture.
5. Drill through the mounting holes on
the j-box template according to the
application's requirements.
8. Drill three (3) holes in the wall that
match the locations of the holes
drilled in step 7 when mounted.
11. Secure the back plate to the j-box
with screws in the holes drilled in
step 5.
3. Open the fixture and disconnect the
connection terminals between the
LED driver and LEDs. Remove the
heatsink from the back plate.
6. Attach the included EVA
foam gasket onto the back
plate.
9. Pull the supply conductors through
the ½" KO center hole on the back
plate.
12. Connect the Line, Neutral and
Ground wires from the driver to
the supply conductors.
WPC Series
Page: 4
REV: 10/29/21
Publicité
Table des Matières
