Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite WallMax™ Cutoff
®
Setting Wattage, Color Temperature (CCT) & Photo Control
2 in 1 Controller (Photo Control & CCT):
Controller
VH- (Blue)
ON
VL- (White)
DIM2- (Gray)
DIM2+ (Purple)
Vo+ (Gray)
OFF
5K
4K
3K
1.
Turn the switch to ON to activate the photocell
2.
Turn the switch to OFF to deactivate the photocell
3.
Adjust the switch on the right to the desired CCT (3000K, 4000K or 5000K)
Wattage Switch:
1.
Adjust the switch to the desired wattage. (28W and 100W models only)
c-Max Sensor Installation
1.
Loosen the two (2) screws with a
Phillips-head screwdriver and take
out the sensor mounting bracket.
3.
Replace the mounting bracket into it's original position. The sensor should be in the plastic cover on the bottom of
the fixture. Secure the bracket with the two (2) screws removed in step 1. Remove the bronze protective plastic cover.
Note: Add a bead of exterior grade silicone sealant around the perimeter of the wall pack on the wall to inhibit any moisture
from attachment bolts.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
V- (Black)
DIM1- (Grey)
DIM1+ (Purple)
V+ (Red)
2.
Remove the rubber plug from the USB-C receptacle. Insert the
sensor into the receptacle. Lock the sensor in place with the
included hex screw and rubber plug.
WPC Series
Page: 3
REV: 10/29/21
Publicité
Table des Matières
