Working On The Device - Laserworld Club Série Mode D'emploi

Manual: Club Series MKII
7. The power supply should be easily
accessible.
8. When installing the laser mount it
with a minimum distance of 15 cm
from walls and objects.
9. For safe setup e.g. on walls or
ceilings please use a safety cord.
The safety cord should be able to
withstand tenfold the weight of
the device. Please follow the ac-
cident prevention regulations of
professional associations and/or
comparable regulations for acci-
dent prevention.
10. If the device has been exposed to
great temperature changes, do
not switch it on immediately. Con-
densation (or any moisture/water
formed) may damage device.
11. Never use dimmer, RC or other

4. Working on the device

1. This product has no user serviceable parts inside and should only be maintai-
ned and serviced by a qualified engineer.
2. Be sure that the mains plug is not connected to the power
supply while installing.
3. Take off all reflecting things like rings, watches etc. before
starting to work with or at the projector.
4. Only use non-reflecting tools to work on device.
5. Wear protective clothing (like goggles, gloves etc.) accor-
ding to laser power and wavelength of the laser.
electronically switched sockets.
Whenever possible, do not use
the laser projector together with
large appliances (especially fog
machines) on the same mains!
12. Ensure sufficient ventilation and
do not place the device on any
warm or heat radiating surface.
Especially the ventilation ope-
nings must not be covered!
13. Ensure that device does not get
overheated. Make sure that the
device is not exposed to spot-
lights (especially moving heads).
Heat of spotlights could overheat
laser in a little while and leads to a
degradation of performance.
14. This unit is intended for indoor
use only.
page 4 / 12 EN