RCF L-Pad 8CX Manuel Utilisateur page 6

FUNCTIONS
PAN or PAN/BAL: This control define the position of the signal into the stereo
image in case of a MONO channel, the balance between left and right in case
of a STEREO channel.
FADERS Ch. 1 - Ch. 2: MONO Channels level control
FADERS Ch. 3/4 - Ch. 5/6: MONO/STEREO channels level control
FADERS Ch. 7/8: STEREO channels level control
MAIN MIX output: Unbalanced TRS jacks. Plug in your active speakers or main sound reinforcement system amplifier (for
passive speakers) of here.
CONTROL ROOM output: Connect to these TRS Jack your Studio Monitor or local speakers.
FX SEND output: The signal going to the Internal FX is replicated in this TRS Jack for different application. If the internal
FX is not used, plug a wedge monitor into this jack for the stage or an external FX device. The processed signal from the FX
device is returned to the RCF mixing consoles mixer via the Stereo Return jacks.
PHONES: TRS stereo jack, Tip = Left, Ring = Right, Sleeve = Common Earth. Plug your headphone in here to listen to MAIN
MIX.
FOOTSWITCH: TS connector, Tip = FX, Sleeve = EARTH. Connect a footswitch here. Press once to bypass the FX, press again
to resume the FX. The same function is available for the FX MUTE button.
INTERNAL FX PROGRAM selector: This encoder select one of the 100 effect preset
from the internal DSP. Press the encoder to confirm the selection. See the FX LIST below
to select the required effect.
FX MUTE button: Switch alternatively ON and OFF the FX return signal (see the red led
PEAK/MUTE) Same function as the FOOTSWITCH input jack.
+48 V PHANTOM POWER ON-OFF switch: Switch on and off the phantom power on
the microphone input. It must be employed when condenser or electret microphones
are used.
OUTPUT LEVEL: These LEDs show the MAIN MIX OUTPUT level. Keep under CLIP level
to prevent generating distorted sounds or dangerous sound levels.
STEREO RETURN control: This defines the STEREO RETURN input signal level routed to
MAIN MIX output.
2TK IN/MP3 control: Defines the level of the signal coming from the 2TK IN input
or coming from optional cards such as RCF mixing consoles PLAYER, RECORDER or
BLUETOOTH optional cards, routed to MAIN MIX output.
TO MAIN MIX/TO CONTROL ROOM switch: Defines where to route the signal coming
from 2TK IN or optional cards: to MAIN MIX when in upper position, to CONTROL
ROOM when pressed (lower position).
PHONES/CONTROL ROOM fader: Defines the level of the signal routed to CONTROL
ROOM output and PHONES output.
MAIN MIX fader: MAIN MIX output level control.
6