User Guide - INFOSEC UPS SYSTEM Z1 zenergy CUBE EX Série Notice D'utilisation

To ensure this product is correctly installed and used appropriately, we highly advise you to read
this user guide very carefully.
1 . I N T R O D U C T I O N
Designed to be extremely efficient and user-friendly, Z1 Zenergy Cube EX is the perfect UPS to
protect your computer and two other accessories simultaneously.
Thanks to High Frequency technology, your computer (Mac or PC) will be protected from power
disturbances, power outages and overloads. Depending on the model and on the connected load,
Z1 Zenergy Cube EX delivers a backup time of up to 11 minutes in the event of an extended
outage, which gives you enough time to save work in progress and properly switch off the
connected loads.
2 . M A I N C H A R A C T E R I S T I C S
 A highly-reliable microprocessor control
 FR/SCHUKO protected UPS outlets
 Cold start feature if no power supply
 Off-mode charging
 Automatic restart during AC power recovery
 Compact size.
3 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
IMPORTANT!
Installing and connecting UPS in a way that does not comply with accepted practices releases
Infosec Communication from any liability.
 Risk of electric shock:
The UPS unit uses potentially hazardous voltages. Do not attempt to disassemble this

equipment as it does not contain accessible components that can be repaired by users.
All repairs should be performed by qualified technicians only.

The utility power outlet shall be near the equipment and easily accessible. To isolate the

UPS from AC input, remove the plug from the utility power outlet.
The mains outlet that supplies the UPS shall be located near the UPS and shall be easily

accessible.
The UPS has its own internal power supply (battery). There is a risk that output sockets

may still be live after the UPS has been disconnected from the mains power supply.
Install the UPS in a temperature and humidity-controlled indoor area free of conductive

interference.
It should not be exposed to direct sunlight or sources of heat. Do not cover the ventilation

slots.
Disconnect the UPS from AC power before cleaning with a damp cloth (no cleaning

products).
In an emergency situation, switch the UPS to the "Off" position and disconnect the unit from

the AC power supply.
When the UPS is out of order, please refer to "section 9 : trouble shooting" and call the

hot line.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
2
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 05 18 AA 59 205 01

User guide