User Guide - INFOSEC UPS SYSTEM E2 LCD Notice D'utilisation

To ensure this product is correctly installed and used appropriately, we highly advise you to
read this user guide very carefully.
1 . I N T R O D U C T I O N
The E2 LCD range consists of high performance pure sine wave UPS units with direct
connection to the PC via a USB port. The UPS is Auto-Regulated to provide balanced output
power and offers complete protection for your servers, gaming PCs, loads with active Power
Factor Conversion power supply, and their critical peripherals like plasma screens for
example in the event of power cuts or fluctuations. If power failure due to power cuts, power
surges, or transient over-voltage occurs, the UPS will very rapidly transfer your computer
equipment to an alternative power supply. This will allow you to make a backup, close your
program(s) and shut the system down correctly. In normal power supply conditions, E2 LCD
will maintain its battery charge in an on-going way to become completely transparent during
all your operations. In other words, this kind of uninterruptible multifunctional power supply
will simplify your tasks. You will be able to check its operating status quite easily as well as
its charge level using the LCD screen. This high-technology UPS ensures that your
equipment has a proper and reliable power supply. The main features of the E2 LCD range
are given below.
2 . M A I N C H A R A C T E R I S T I C S
On Line Performance technology providing pure sine wave output
Highly-reliable microprocessor control
Automatic Boost & Buck output voltage regulator (AVR)
Built-in USB communication port
Input voltage regulation and standardization
Cold start feature if no power supply
Off-mode charging
Green Power Function for energy saving (from 1000 VA models and higher)
Built-in super smart battery charger
Automatic restart during AC power recovery
LCD screen
Phone / modem or network surge protection (RJ11/45 connectors)
3 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
Risk of Electric Shock:
The UPS unit uses potentially hazardous voltages. Do not attempt to disassemble
this equipment as it does not contain accessible components that can be repaired by
users.
All repairs should be performed by qualified technicians only.
The utility power outlet shall be near the equipment and easily accessible. To isolate
the UPS from AC input, remove the plug from the utility power outlet.
The mains outlet that supplies the UPS shall be located near the UPS and shall be
easily accessible.
The UPS has its own internal power supply (battery). There is a risk that output
sockets may still be live after the UPS has been disconnected from the mains power
supply.
Install the UPS in a temperature and humidity-controlled indoor area free of
conductive interference.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
2
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 08 12 AA 59 205 19

User guide