Wiring - Audiovox Phase Linear UCD300 Manuel De L'utilisateur

UCD300/UMP400

WIRING

connector is for the right and the
WARNING! Never combine (bridge) outputs
for use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
CAUTION: Failure to wire exactly as shown
may cause electrical damage to the radio.
Antenna Connector
Amplifier Wiring
Connect line out for optional
external amplifiers. The red
white connector is for the left.
10A
Gray
LF/AVG
White/Black (-) Gray/Black (-)
White (+) Gray (+)
LR/ARG
Green/Black (-) Violet/Black (-)
Green (+) Violet (+)
5
Power Antenna
Connect to power antenna
or amplifier. If not used, tape
Blue
bare end of wire.
Ground
Black
Connect to ground terminal.
Memory/Battery
Yellow
+
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Red
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
RF/AVD
Fuses
When replacing a fuse, make
sure the new fuse is the correct
type (ATO) and amperage.
RR/ARD
Using an incorrect fuse could
damage the radio.
CD Changer
Connector