Cd Changer Controls - Audiovox Phase Linear UCD300 Manuel De L'utilisateur

CD CHANGER CONTROLS

Built into the UCD300 and UCD400 are controls
to operate an optional CD changer. Please
check with your Phase Linear/Audiovox car
stereo specialist or call 1-800-323-4815 for
recommendations of the models that will work
with this radio.
Adjustment of the audio functions (volume,
tone, balance, and fader) and CD functions
(Pause/Play, SCN, SHF, RPT and TRACK
selection) for the CD changer operate in the
same manner as they do for radio play. See the
Operation and CD Player Operation sections
for information about these topics.
The following controls will operate an optional
CD changer when it is installed and connected
to this radio. Refer to the owner's manual
included with the CD changer for instructions
on the installation and correct loading and use
of the CD magazine.
CD Changer Mode Selector
14
(MODE)
Press the MODE button (14) to select operation
of the CD changer, as shown by "CDC" on the
display panel. Disc play will begin and the disc
and track number will be shown on the display
panel. If a new magazine has been loaded into
the changer, play will begin from the first track
of the first disc in the magazine. If a magazine
was already in the changer, play will resume
from the track on the disc previously in play.
RELEASE
/
PWR
EQ
SEL
AS/PS
14
, Disc Select (5CD-/6CD+)
21 22
These CD-/+ buttons (21 and 22) are used to
select the desired disc for play. To advance to a
lower number disc, press the 5 CD- button (21).
To return to a higher number disc, press the 6
CD+ button (22). The number of the disc in play
will be shown on the display panel.
UCD300
AM / FM / CD RECEIVER
1 2 3 4 5 6
SCN RPT SHF CD- CD+
PAU
22
21
UCD300/UMP400
EJECT
MON
DSP
TUNE
LOC
> > >
TRACK
BAND
MUT
LOUD
MODE
14