Human Touch ht 135 Mode D'emploi page 4

get ready
Unpack the box
Chair Seat Pad
1. Unfold the chair
Remove all packaging materials from the
chair. Pull up on the backrest to unfold the
chair to an upright position. The backrest
locks into place automatically.
7
humantouch.com
Backrest Pad Head Pillow
2. Attach the backrest pad
Attach the top backrest pad flap to the top of the
backrest. Smooth the two bottom flaps under the bottom
of the backrest. Attach each side flap to the side of the
backrest. All flaps attach using hook and loop fasteners.
Your Human Touch massage chair
simple assembly (no tools required). Just attach
the backrest pad, the seat pad and the head
pillow, and you're done!
3. Power on
Plug the chair into a 230-volt power source. Turn the
master power switch (on the bottom centre of the chair
back) to On.
4. Attach the seat pad
Use the remote control Leg Up setting to raise the footrest to a horizontal
position. Attach the seat pad to the back of the seat, using the hook and loop
fasteners. Wrap the flap on the front of the seat pad around the chair frame
and attach it to the top of the chair frame using the hook and loop fasteners.
5. Attach the head pillow
Flip the flap on the back of the headrest up and over
the top of the chair. Attach the head pillow to the flap
using the hook and loop fasteners. Adjust the head pillow
height for maximum comfort.
8
requires some